Plastic Fantastic 2

other then put the dash back in (4 screws) I have nothing really to do to be ready to run. I can even leave the rear in it... I won't because it's so simple to change - but that was kind of the deciding factor. If I can, why not?
 
Going into cold storage, so need to finish up some things
yeah, my favorite, wiring
VCB2ECg.jpg

better
nj9UOAV.jpg

it all works right... winning
fvoU3bF.jpg

so this is going to my new shop in Idaho - so it goes with all its parts. the list of to do: put the 3.42 diff in, swap valve springs, finish the light change, figure out the diffuser for high speed in October.... what I do I need to do before spring autox? none of it - so it gets to sit while I get more pressing things done related to the move
mkdlXdK.jpg

but for now, it sits on a charger while I get more stuff moved
 
I know I've been MIA for a minute. We're moving to Sandpoint Idaho. My fantastic shop... selling... but my new fantastic shop will probably break ground this summer. I hope to run Optima at Thunderhill in October... we will see
5xbxBALh.jpg

my 'new' shop... a garage condo. It will be where I do lift work and 4x4 work. My plan is work on the Buick (sorry, not the 50 yet) in my hobby time. Blazer is nearing completion but I haven't yet started on the camper for it. That's coming soon too... along with building a 60x60x25 2 story shop and a 3200 square foot house... it'll be cool when it's done and I'm really where I've always wanted to be.
 
Moving, building a shop, building a house, building a couple of vehicles,.... You know how to keep yourself busy!
 
back to this, first an oil change
I bought this filter last year at SEMA, finally getting around to doing the oil change to do it
ykZMbHlh.jpg

SUN6sVRh.jpg

next up, change the rear diff back to the original... I literally lost 10 mph off my top speed with the higher ratio (3.42 stock v. 3.91 currently)
 
You’ve probably seen these, I grabbed a photo because it looked homemade, and it had a simple design. But, looks like it may be a professionally manufactured one. IMG_4129.jpeg

On another note, the admin should move the Projects back to the top of the page in my opinion.
 
You must log in or register to reply here.

Latest posts

Back
Top