turtlevette
The Turdle
Has anyone tried the welding the bearing race trick to get it to drop out.
Has anyone tried the welding the bearing race trick to get it to drop out.
Has anyone tried the welding the bearing race trick to get it to drop out.
Nope. Just beat it out with a drift from the back side.
A brass drift, a 2lb. drill hammer and a game of "whack-a-mole" always seem to work fine.
use anto spatter spray to avoid getting weld spatter where you don't want it
Has anyone tried the welding the bearing race trick to get it to drop out.
Nope. Just beat it out with a drift from the back side.
A brass drift, a 2lb. drill hammer and a game of "whack-a-mole" always seem to work fine.
I disagree. Whacking the shit out of them tears up the seating surface. Mine are marred up for that very reason and need to be refinished with sandpaper next time. I find it very tedious and time consuming to bang on these suckers for 2 hours.
I'm going to try welding a ring around the inside of the race next time. I have some spare rear bearing housings i'm going to practice on.
use anto spatter spray to avoid getting weld spatter where you don't want it
I looked up anti spatter spray. I had never heard of it.
That's amazing. Thanks for the tip!
Guys, anyone give me a fizzicks lesson here....WHY is this true??
dying to know....serious....short one/two sentence will do, I hope....
:hissyfit: