vette427sbc
Well-known member
Just about done with the brake ducts for my vette. Heres some pics-
Dust shields cut away, and 3" exhaust tubing welded in place. I had to oval the tube to direct all of the air to the center of the rotor.
I bought 10 feet of 300* 3" brake duct (Just barely enough) and ran it from my front brake ducts up inside the frame rails and over the control arms.
I had to clearance the inner fender so that my control arm doesnt crush the tubing. You can just barely see the cut at the top of the picture.
And for those of you wondering where my brake ducts are in the front... Heres a teaser shot... Still need to finish that up
(dont mind the rust
)
Dust shields cut away, and 3" exhaust tubing welded in place. I had to oval the tube to direct all of the air to the center of the rotor.
I bought 10 feet of 300* 3" brake duct (Just barely enough) and ran it from my front brake ducts up inside the frame rails and over the control arms.
I had to clearance the inner fender so that my control arm doesnt crush the tubing. You can just barely see the cut at the top of the picture.
And for those of you wondering where my brake ducts are in the front... Heres a teaser shot... Still need to finish that up
(dont mind the rust
)
