Recent content by Curby

Some of you are familiar with my 72 Vette, Michele. I have had her for a few years now and had decades of fun. She came to me with a piss poor paint job and running like crap. When I got her, she had a GM ZZ454 engine in her with an M22 4-speed. She had been used, abused, and put away wet...

A heated one comes with the FAST kit. I looked this evening, and I think I can put it on the inside, but I will still notch the bottom of the frame rail with a half piece of roll bar tubing so the O2 sensor is not the lowest piece on the car.

OK, just bought my EZ EFI system for the 72 big block. She has the Hooker Super Comp headers on her, which has the collector outside the frame rails. Does anybody have suggestions for the wideband O2 sensor location? I have seen them in th top of the collector right by the egg crate, but I...

I am beefing up my 72 big block for some dragstrip use. gary is goign to build me a 3.70 diff if I eer get the crate built to ship it to him. I have some new 3" half shafts with solid u-joints, and a good custom driveshaft that came with my TKO600 transmission. I have been looking at...

Hi, all! This is your opportunity to drive your car on the superspeedway. A local charity that I support has the track rented for the day. We will have sessions with 15 to 20 cars each every 15 minutes or so. The sessions will be 5 laps each, paced by the track's safety crew at about 90 miles...

Anybody tried the NISSAN 300ZX calipers I swapped out my factory single cast iron calipers on my 1994 Q45 with the 1990 300ZX Twin Turbo aluminum 4 piston calipers on the front and the 2 piston calipers on the rear. Fortunately for me, the mounts were exaxtly the same. The rear rotors were...

looks like you would have to put one on the front and one on the back. My 71 that I got yesterday has manual brakes, manual steering, and no A/C It is amazing how much room is in the engine bay!

I just ordered the Millermatic 180 for all my stell welding, and a Miller Econotig specificially for the detail stuff, aluminum, and stainless steel.:yahoo: I have been worrying over this purchase for several months, and decided on the Miller products. It has been a while since I have welded...