T5 part: what's its name / where to find it

[denpo]

Preparing the G-Force case for the rebuilt, I'm stripping the old case and found a part impossible to remove.
This is the pivot of the reverse lever that bolt above the reverse switch, at the middle top of this image :


I even brought it to a garage nearby, they broke a T30? head trying to unbolt it. Any idea on how to remove this sucker?
I just can't find the exact name of this, thus I can't find it on Ebay nor Summit.

I need your help on this guys.

 

[JeffP1167]

If it is torx use a impact driver with the torx attached to it and bang it hard with a hammer and it should break free.

 

[denpo]

If it is torx use a impact driver with the torx attached to it and bang it hard with a hammer and it should break free.

That what the guy at the garage tried (impact driver)... his torx head exploded :crap:

I'll try tonight to heat it and bang the hell out of it. In case it won't move I'd like to know the name of the part.

 

[Twin_Turbo]

The golden part? The 5r shift lever?? There's a retainer clip on it.

Remove the spring on the reverse shift rail and pull the rail out, that will give you access to the clip.

 

[Twin_Turbo]

http://www.zbag.com/T-5_Service_Manual_1.pdf

Might help

 

[denpo]

Thanks TT.
So the part is called the pivot pin.

 

[MYBAD79]

wow, if I had any transmission work in my future I'd save that file

 

[TimAT]

wow, if I had any transmission work in my future I'd save that file

WOW-- there's springs and gearz and stuff in therehoto:

 

[denpo]

wow, if I had any transmission work in my future I'd save that file

You then might enjoy this one as well :
www.flatheadv8.org/T5Rebuild.pdf
To my regret this pdf (I downloaded a while ago) was containing the information too, I should have thought about this, sorry:noob:
Good to know it's wasn't entirely pointless.
Went from work too late, can't hammer like crazy that late, will try to whack the little fucker ASAP.

 

[DeeVeeEight]

http://www.zbag.com/T-5_Service_Manual_1.pdf

Might help

Nice link! Do you have one for a Tremec TKO-II?

 

[denpo]

Ok, tried everything I could, heat, hammer, nothing could make the sucker move.
NAPA don't sell this parts, at least here in Canada.
So, before I cut my old case to break it free, I'm doing one last call if someone knows where to find it.
On the diagram below, it's the part #149 (bottom left), allegedly called "pivot pin".

 

[Twin_Turbo]

The pin is not a service part during rebuild so it's left in. Since you are swapping cases, heat will be the solution. Try localized heat with a small torch. Never removed the pin before. Hope you succeed.

Sent from my GT-I9000 using Tapatalk