69427
The Artist formerly known as Turbo84
I've been looking around, and have been striking out so far. I'm going to be running AN-3 lines to the caliper, but I need to adapt the stock C3 junction block to AN. The junction block uses 7/16-20 thread with the normal flare, but no one (that I know of) makes an adaptor to screw into the junction block that would also have a -3 male on the other end. I talked to Earl's in Indy today, and the tech guy suggested getting a -4 to -3 coupler/reducer, and then cut off the tip of the -4 side (it has the needed 7/16-20 threads), and then drill into it a bit to form a beveled surface to seat into the junction internal flare surface. The concept is simple, and as a last resort I could do that, but I'm curious if anyone has other options to try.
Thanks,
Mike
Thanks,
Mike