73 Mike
I'll drive it someday
A number of my fittings look like they are round rather than fittings. Given the number of other brake system issues that I'm having, I think I'm just going to change all of the lines. There are a couple of places that I've found where the lines have been distorted and I simply can't be sure if these are the cause of the flow restriction that I'm seeing.
Out of habbit, I've always replaced lines with stainless so I don't have to do it again, but I do notice that you have to tighten these more to achieve a good seal.
Any suggestions one way or another? The small difference in cost doesn't bother me but leaks do.
Out of habbit, I've always replaced lines with stainless so I don't have to do it again, but I do notice that you have to tighten these more to achieve a good seal.
Any suggestions one way or another? The small difference in cost doesn't bother me but leaks do.
Last edited: