Reply to thread

Message: <blockquote data-quote="sssuch" data-source="post: 120637" data-attributes="member: 1295">Just metric threads that all of the new Cars use nowdays. The front was 12mm x 1.0 thread for the 3/16 line this one is common and I had it in My NAPA tube nut set.  The rear port was 12MM X 1.50 thread was a little harder to find (the parts stores are clueless around here). I found it on amazon , here is the link:[ame]http://www.amazon.com/gp/product/B00J2FU5P4[/ame]Use Your old line and just do a Metric Bubble flair , if the new Tube Nut is too tight on the SAE Line just run a 1/4 Drill bit thru it. Works great.</blockquote>