Recent content by Jclgodale3

Thanks. I decided to seperate them with a piece of hose

or is a braided hose necessary between the Walbro pump and filter? Opinions?

Ok. The late model LT1 is now done and installed in the 68. I would like some guidance on the fuel system. I do not want to change gas tanks or install an "in tank" fuel pump. I want to use an external/inline pump. What are your suggestions for: Pump? I was thinking a WALBRO Universal External...

Can someone tell me the size, thread and length of our stock rear spring bolts? I want to go longer but not necessarily to 8 or 10 inch bolts...thanks

on a 327 "J281". It is a 3782870 block. Does October 28th of 1961 sound right?

In installing my 1994 LT1 in the 68 Vette, are there special reverse flow radiators that have to be used? Or can a stock type radiator be used?:mad:

http://vettetube.com/view_video.php?viewkey=935defcb1f9e247a97c0

Still debating on putting the original Turbo 400 in the 68 Vert with the late model LT! or going with an OD tranny. Found this 700R4 at a fairly good price out of a 99 Chevy pickup. Will it work? And what all would have to be modified/changed for it to go in the 68? Thanks!

Anyone know of a good supplier of welch plugs? I need a couple 5/8" welch plugs to terminate my heater hose fittings on the 94 LT1 water pump. Anyone?

Would like to go with an external fuel pump and regulator for the LT1 going into the 68. Any recommendations? Brands? Specs?

Here's a few pictures of the almost completed late model LT1 going in the 68 Vert I was asking questions about. The wiring harness will be a different story:suicide: It almost complete and I converted the old vette PS pump to serpentine setup. As you can see, all accessories have been moved to...

Would anyone happen to have a stock drivers side cast alternator bracket that mounts to the 2 holes in the front of the drivers side cylinder head? In bad need of one...help? Thanks

Accidently started a pissing match over at that other place about whether my 94 LT1 I'm putting into the 68 Vette is internally or externally balanced. Which is it? If externally balanced, do I need a weighted flexplate for the Turbo 400?

Did you ask for just a hub?

Folks...still looking for a more modern 350 for my 68 Project. Found a 94 LT1 from a Buick Roadmaster with computer and wiring. What are the differences between GM models in these later years? Need advice as I need to make a decision sooner than later...thanks:crap: