Recent content by gimpy

Agree ^, little brother using a a BTO trans. in a 63 Nova /ZZ3,excellent service .I've used their parts in my 700r4 setup with good results. Gimpy

Inspired by My Bad 79, and a very loose and leaky stock set up,I jumped.I couldn't locate a manual gear so I used a powered rack, from a 88 Citation giving me 2.7 turns lock to lock.I've looked and searched this for a long time, decided to use Riggs 74 set up with two Grand Am tie rods.The...

OK fellas,I've been a member here for a little bit,haven't posted much,just been ghosting along ,getting info and watching all the good work.Impressive stuff. I put up a pic of this in the EFI section, but I think it belongs here. So here goes. When I bought my '77 it had a tired 350 in it with...

My 77 is in need of another differential.I've taken mine from together,and it needs to be rebuilt,but if I can find a decent one I'd rather go that route.Mine is a 3.08,would like to stay with this ratio but am considering 3.36.Does anyone have something? Gimpy

Can do. Gimpy

Thanks guys,As for adjusting between throttle bodies(pairs of them)I made these little gizmos(copied from Kinsler FI) But these are protos and will change I'm sure. I'm in hopes that because the shafts where cut a pair at a time there will not be any large diff. in one throttle body,only in...

Tpi/ITB I'm a Noob here,but I've been fabing parts for this little project for about 3 or 4 months(spare time) I started with a Scroogins Dicky TPI base plate for Vortec heads,took tpi runners and removed the 1.5 id tubes,bored to 1.625 id ,cbored 1.75 @ .3 depth.Added 1.75 mandrel bent 1.75...

Hi from the land O flat(Nebraska)Just found this forum,and have always modded everything I've ever owned.Current toys include a 90 Mazda B2200 that's running a 89 Probe GT engine complete with turbo and Mega Squirt EFI,RX7 gear box,puts like 180 hp to the wheels(never dynoed)A 77 Corvette...