Recent content by DARROW 74

Well as some of you know I have a new car. So I started checking a little deeper and found that a lot of nuts and bolts were not more then hand tight. Well being the way I am I wanted it done right so this is where I am at. So I though seeing as I like working on them as much as I like driving...

Well its over. and hargerty has come through just like they said they would. there was one small problem But one phone call worked that out. When they say agreed price they mean agreed price plus the tow bill ($510) So the next time you think insurance Check it out carefully.. Oh I did keep...

Where can I find color samples from 1971 like mille miglia red

OK what do these lip # mean TO901CPH C11S108608 Most I know But the C11 I can,t find :quote:

Was there a service manual for the 1971 vette?

Is there any books on setting up a tv cable on 700 r4 TO A quad carb. I am in the process of installing the rebuilt hp 87, 700 r4 in my small block 73. and need all the info I CAN GET ON IT. Thanks I see a lot on the net but 1ST hand is better.

http://www.youtube.com/watch?v=uJDoFnW32FU

CLICK ON THIS https://www.evernote.com/pub/1darrow/crash This says it all, Good thing I belive in seat belts.

Hay bird the solar is putting out 445 vdc in this weather. I better get it grounded, And get the a/c hooked up, Well maybe today:):):)

On my new lap top I can not post on vetteMOD, But on my old desk top all works fine. On the new one It keeps telling me, my message is to short.?????:crap: What am I doing wrong any ideas?

Need a 90 degree adapter for the speedo cable at the trans, this is on a 74 4 speed I think most older years will work. Mine got ground a bit.

New Pictures WELL ONE STEP CLOSER. More to come when it running.... ( old boat motor)

more pictures . More pictures of stand :stirpot:

Well I seen fuelies run stand and thought since I have wanted one for a while that I would give it a shot. there is a lot of metal in one of these things. I got plans off the enter net for $8.50 And I have a 120 volt wire feed welder that works fair, considering that I have not welded in few...

FOUND THIS ON CRAIGSLIST (not for me) http://sfbay.craigslist.org/eby/pts/1731727921.html What do you think?