Recent content by corvettedave01

Hi all, I was going to go with a Dana 60, but the highest gear is 3.54, which won't allow me to finish the quarter mile in 3rd gear. So...I'm back to square 1 and strongly considering the whole welded up Ford 9" from Autofab as I can't piece one together for much less than they can do an...

Very nice Gordon! Well, everything but the coil location...lol

How strong are those Denny's aluminum halfshafts? I didn't see any info like that on the webpage. How much hp/tq could they handle? Are they stronger than the Tom's 3.5" steel half shafts?

yeah, it would take a hole in the hood up by the drive pulleys, even with an L88 hood. The cool thing is that the top is flat and the TB comes out the side; way closer to fitting than the normal roots style blowers with the carbs on the top. I'm just looking for a good blower solution and was...

Anyone ever use one of these? I wonder if it would fit under the hood...

Hey guys. I did basically the same thing TT did, with the same Summit sump. However, since I couldn't weld the thin tank, it ended up costing me quite a bit, could have got a better tank for the money I had into it I'm sure. I also need to put a -10an feed line to the pump and run the return...

Just a couple of comments to consider. I have a 427 sb with a bit more solid roller cam, but real similar combo with a FAST xfi and currently 48# injectors running at 43 psi. I'm running in bank to bank alph N mode atm. 1. When I was tuning mine, the wideband sensor got saturated at first...

Thanks for the feedback guys, might go drive it around in a bit, too cold to do much else :) Anyone know where to get some good tail light assemblies for a '76? $200 in Ecklers is a bit steep.