Recent content by chevy69

Hey guys - been a while but thought I would drop by. I've been messing around with older stuff mainly - still buiding my '38 Dodge business coupe. Got the brakes all plumbed and messing with the AC and the fuel system now. Got the gauges figured out and built a bench seat for it from an old...

Purchased for $3394 for my project, but never used. 0 miles on this transmission. Comes with shifter, speedo cable, clutch disk and gear pattern plate. $2750 plus shipping

sold - heading to Oklahoma

Hey guys - I haven't been doing much with the C3 and have kind of put the '69 on the back burner for a while (after getting the body back on the chassis). I have been devoting serious time to my '38 Dodge, I shot black satin paint on it over the holidays (john deere blitz black). I hope to be...

I agree with this approach. So just to be clear, I certainly wasn't advocating any of the solutions spelled out in Hot Rod this month - just pointing out that the technology continues to evolve and that more and more players are entering the market. This will ultimately drive pricing down...

I haven't gotten through it all but here's what they cover: A briefing on 12 different vendors offering EFI kits where they address: - a little about each company - what kits they offer - what options are available - what is needed outside of using the kits to get on the road - how do you tune...

They go through a bunch of aftermarket kits, installs, etc...

Hey guys. Here are a few pics of my '69 coupe. I'm concerned about the height at this point. The measurements from the floor to the fender "lip" are 29" (+) in the front and almost 31" in the rear. I did use the thicker 73 and up poly kit vs. the old aluminum bushings so this adds to the...

I am swapping my '69 Coupe's short hood and wiper door assembly for a long hood from a '73-74 model. I have the hood already (it's a cowl induction hood from a '74). I am trying to figure out what the old wiper door area will look like after I'm done with the swap, and need some pictures of...

I'll start, I have a 1938 Dodge Brothers biz coupe I'm working on besides the '69 vette. It's a street rod project I have been working on for ~ 6 years. It's all steel, and has many of the typical street rod features - however - being a Dodge - there is much less out there wrt kits and the...

Hey guys - I'm guessing there are many here from CF and DC. I have the same personality on each site, so no secrets here. Getting a little worn out at the other place and wanted to pop in and learn some new stuff. My '69 coupe is 3yrs into a frame off - body went back on last month and going...