Recent content by AGVI

👋

OOH, NICE! Which Blueprint engine did you get?

Wow, that's light!

What will my time be when I'm all setup? 550HP/500TQ, Bowtieoverdrive 200R4 3000 stall, 3.70 gears. :drink:

I think I should start with 1) Removing the under drive pulleys. 2) Remove the A/C condenser that is blocking air flow to the rad 3) Install the rad seals. 4) Install electric fans 5) Go with a mix of less coolant/more water and some water wetter additive. 6) I know a proper tune can help also...

Alrighty, I have a 550HP 500TQ 406 and was wondering if updating my torque converter from the stock unit will make that much of a difference in terms of acceleration. Should I look into a higher rear gear ratio also? I currently have a TH350C lockup transmission and 3.07 gears. The car is...

I recently installed a 406 and it was popping through the exhaust. The headlights and other vacuum accessories were running through the carb. I moved the vacuum accessories to run off the intake and the popping went away. I went on a short trip (5 miles) the other day and it started hesitating...

Some of the CF boys and myself installed a 550HP 406 into my '80. Here are some pics.....vids to follow. :drink: Getting the engine from Motorhead's place :nuts: Frank (Maymyvetteliveforever) and Alex (75Stingray!)...nice butt there Frank:lol: Out with the old... Mike (RAGGDOLL)...