![]() |
|
![]() |
#1
|
||||
|
||||
![]() I need to merge shorty headers on a BB Corvette with Magnaflow pipes on a car that does not have a body on it. Wanted to make sure I cleared the floor of the car, oil filter and starter and have the pipes no lower than the oil pan. So I built this 2x4 holding fixture that maintains alignment from the header flange to the crossmember tubes that the pipes go through.
Noe that I have this I'm thinking I could use it to make some long tube headers! ![]() ![]()
__________________
|
#5
|
||||
|
||||
![]() I'm a fan of making a jig whenever possible.
The alternative is having to weld stuff underneath the car, which is damn uncomfortable, both physically and mentally (regarding fire). Keep the pictures coming as progress happens. ![]() |
![]() |
Thread Tools | |
|
|
![]() |
![]() |