Are the mounts for the bat wings on a c4 mounted square or are the mounts tipped for a bit of pinion angle?
I am working on making the mounts, but I am not sure if I should weld them square with the frame or 3 degrees off to set a 3 degree pinion angle. I am fastening the front of the differential to a cross member rather than using the torque bar
This is on a hot rod rather than an actual corvette.
I guess what I need to know, is the differential set square with the mount or is it angled?
Thanks
I am working on making the mounts, but I am not sure if I should weld them square with the frame or 3 degrees off to set a 3 degree pinion angle. I am fastening the front of the differential to a cross member rather than using the torque bar
This is on a hot rod rather than an actual corvette.
I guess what I need to know, is the differential set square with the mount or is it angled?
Thanks