What should it cost to have them made? Where or who can make them?
What should it cost to have them made? Where or who can make them?
Thanks. I still have the R&P center bracket to make. Then it's wheels and tires and putting the body on. That will be a big help since this is taking up both sides of my garage.
Yes. The tie rods have been lengthened (18 3/8 L) by welding a piece in the middle.
Yes I am raising the inner joint over the stock setup. Next step is to make a bracket for the rack & pinion.
I did lay it out in CAD. This just confirms what I found.
Yes. The tie rods have been lengthened (18 3/8 L) by welding a piece in the middle.
How are you measuring the length of the rods?? I measured center to center, on grease fittings with car aligned.....