Stahl Sbc headers

sharethewealth said:
phantomjock said:
We could not have done this work without the use of some really cool header tools:

12695c19771e322c4.jpg

They go for about a hundred a set and I have two sets - that will let go for $100 + shipping -- Shameless sales plug - I know. I'll post in sales section full details tomorrow.

Cheers - Jim
Click to expand...





Thank you,
Tim
Click to expand...

Thanks for posting that, pretty easy to fab.

After I saw the Duntov headers at $4000 a set, I figure I'll try those someday.

http://www.duntovmotors.com/vintage-racing-parts-engine_driveline.php
 
I bet that is for me...

redvetracr thats a lot of heat so close to your oil pan...
Click to expand...

Yep. So now moving to a dry sump setup -- and may move to Schoenfeld "over the top" headers sitting on the shelf. But then the heat will be nearer the carbs -- argh... Compromises again and again.

Still shopping for a 1 piece RMS Dry Sump Pan with multiple scavenge pick ups. Putting a call in to ARE. May cost more - but end my quest. Been looking for minimum height, but changing the header option opens up a bit of depth too.

Cheers - Jim
 
You must log in or register to reply here.
Top