69427
The Artist formerly known as Turbo84
I'm trying to modify a junkyard rear swaybar (off an old Oldsmobile FWD car) to fit my '69. I need to bend the arms inward a bit more (they're about 15* outward from a right angle, and I need to bend them so they're about 15* inward), but it's a tubular bar (metric, about .600" diameter and .100" wall), and I'm trying to keep from collapsing the tubing at the bend. Looking for suggestions on how to to do this. I've seen guys fill tubing/pipe with sand to keep the bend from collapsing, but I'm upen to any intelligent suggestions. If I'm sucessful with the bend change, I still need to modify the arm lengths and end link terminations.
Thanks for any help.
Thanks for any help.