3" Brake ducts on my '69

vette427sbc

Well-known member
Joined
Sep 25, 2008
Messages
1,034
Location
Jersey Shore
Just about done with the brake ducts for my vette. Heres some pics-

Dust shields cut away, and 3" exhaust tubing welded in place. I had to oval the tube to direct all of the air to the center of the rotor.
DSCF1164.jpg
DSCF1163.jpg

I bought 10 feet of 300* 3" brake duct (Just barely enough) and ran it from my front brake ducts up inside the frame rails and over the control arms.
DSCF1185.jpg
DSCF1178.jpg
DSCF1180.jpg

I had to clearance the inner fender so that my control arm doesnt crush the tubing. You can just barely see the cut at the top of the picture.
DSCF1184.jpg
DSCF1183.jpg

And for those of you wondering where my brake ducts are in the front... Heres a teaser shot... Still need to finish that up
(dont mind the rust:sick:)
DSCF1181.jpg
 
Yes...
DSCF1169.jpg

I still need to fab up two more support rods. If the weather holds up, and I finish some other things Ill be able to get some pics of it completed tomorrow.
 
Top