Dimple dies

Is this sort of the same principal as a greenlee knock out punch except you need a hydraulic press instead of the greenlea press?
 
Last edited:
Its not a knockout punch/radio punch but it's a flaring/belling tool for round holes to make it stronger. A good example is the big hole for access to the power steering ram outer mount stud plates (geez what a way to describe those) on your chassis (drivers side)
 
They have heat treated and mild steel. I don't know how long the mild steel ones would last if you do heavier stuff like 1/8" but the thinner stuff it should be fine.

7 dies for 150 shipped is unbeatable though

I cant think of too many places to use them on the vette though. They are very popular on rock crawlers though.
 
i'm only doing alu with them and maybe an odd piece of steel sheetmetal
 
I am getting these but I am wondering where to use them on the vette lol

Any ideas?
 
You must log in or register to reply here.
Top