Fender to bonding strip. Can I use???

BlackRat

Well-known member
Joined
Mar 27, 2008
Messages
196
When I had my mishapp and crumpled the fender a small sextion maybe 3" long at the bottom corner of the fender at the passenger door came loose from the bonding strip. Is there an off the shelf 2 part epoxy I can get from AUtozone, O'Reilly or some other parts house that I can use to re bond this area?

I know I can get binding adhesive from Eckler's or one of the other mail order places but this area is so small I thought I could get by with something else.

Thanks
Wade
 
About the only thing I can think of would be JB Weld. I am sure Noonie, Smyda, or Big G know better.
 
For that probably a syrup viscosity would be best. Pry it up enough to get some rough sandpaper and clean with starter fluid and just pour or squirt some epoxy mix.
Don't know your location, but a Boat US or West Marine
For smaller quantity just use JBWeld. It's just the same old epoxy with differnet shit mixed with it. Will work the same and a lot cheaper.
 
Top