Aluminum rockers or stainless?

So I'm trying to decide whether or not it's worth the extra money for aluminum roller rockers over stainless roller rockers for an engine that I shift at 6K rpm.

Get the stainless ones, if you get alu make sure you get comps, crane, HS, not offshore junk.

V-Twin said:

Get the stainless ones, if you get alu make sure you get comps, crane, HS, not offshore junk.

Click to expand...

Made that mistake once already! This is why I'm buying new ones 3 years later.

Might want to check out these guys:

http://shop.enginekits.com/osb/showitem.cfm?Category=363

Powerhouse...? I've never heard of them. And everyone advertises how great their fulcrum bearings are but no one says anything about the roller tips. And that's what failed on me, the roller tips.

I have a set of some large glommey looking aluminum cast roller rockers/tips and there been there for some 11 years now, and maybe 100k miles....every once in a while it sees 6 grand, but not but maybe 4-6 times in those miles....

but I have to say they work fine...so far.....I forget the maker....

they coast me 160 bux, THAT I remember...:trumpet::hi::crutches: